Hello Guest it is September 22, 2023, 03:05:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Toc Brian

Pages: 1
General Mach Discussion / Re: Touch Probe Problem
« on: March 30, 2009, 01:45:09 AM »
Great....Thanks Guys...Will give it a Shot

General Mach Discussion / Re: Touch Probe Problem
« on: March 29, 2009, 08:12:28 PM »
Thanks Dave....I looked all over there but all I could find from gary was he downloaded the screen and code seperate.....where is the code?

General Mach Discussion / Touch Probe Problem
« on: March 28, 2009, 08:25:44 AM »
I have the touch probe setup on my machine and sometimes it feeds down touches and comes up .300 and stops as it should

But sometimes it goes up 2 inches dwells and goes up again.....Why is it doing this...?

Hi guys......this is Brian from the Taig Owners Club

Wanted to pop in and say Hi and Thank You to Artsoft for Sponsering the Free Mach 3 License Drawing,

Thanks Again

Pages: 1