Hello Guest it is October 28, 2020, 02:12:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dgowland

Pages: 1
1
Show"N"Tell ( Your Machines) / Re: Smithy 1240 CNC and enclosure
« on: February 05, 2009, 06:31:34 PM »
So how is the mill working so far ? Have and part pictures to show the finish ?

Dave

2
Show"N"Tell ( Your Machines) / Re: Smithy 1240 CNC and enclosure
« on: January 27, 2009, 10:40:53 PM »
When you mentioned a servo change over what components where you thinking of using ? I was thinking of the same thing . Novakon is near me with the same mill . I was thinking of buying less the controller also .

Dave

3
Show"N"Tell ( Your Machines) / Re: Smithy 1240 CNC and enclosure
« on: January 25, 2009, 08:59:46 PM »
Think the mill could handle more hp and RPM ?

Dave

4
Show"N"Tell ( Your Machines) / Re: Smithy 1240 CNC and enclosure
« on: January 25, 2009, 04:09:11 PM »
Sounds good , thank you for your opinion . That is a good idea for the Z , I like that .

Dave

5
Show"N"Tell ( Your Machines) / Re: Smithy 1240 CNC and enclosure
« on: January 25, 2009, 11:58:01 AM »
I like the enclosure , good job . I was thinking of the same mill but from another comany . What kind of feeds and rapids will it work at ? Did you reuse the 1700oz steppers ? Does it seem decent as far is being solid . What would you change if you had a choice ?

Thanks
Dave

Pages: 1