Hello Guest it is March 29, 2024, 07:46:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LJ4133

Pages: 1
1
General Mach Discussion / Abnormal Condition 5166
« on: January 22, 2009, 07:34:27 AM »
I was in the middle of a run and the y servo motor on the right side quit and ruined my project. I'm using Mach 3 and have an error code in Mach 3 that says "abnormal condition 5166".  When I switch cables from the right and left motors the right side works, so the motor does work. I've checked all connections and they seem good.

Can anyone tell me what that 5166 means?

Thanks in advance.

Pages: 1