Messages

1

General Mach Discussion / Re: Control VFD/Spindle via Breakout board and mach3.

« on: November 24, 2018, 11:29:17 AM »

Hello
look on this site you will find your happiness
at home it works perfectly ....
you even have the actual rotational speed of the spindle display on MACH3
good luck.....
http://royaumedeole.fr/informatique/plugin-mach3-pour-vfdhuanyang/mach3-plugin-for-huanyang-vfd/

2

General Mach Discussion / Re: huanyang vfd and mach3

« on: October 05, 2018, 09:33:27 AM »

Hello
a good site where you can find a plugin for the Huanyang VFD and Mach3
I use it for years and it works very well

http://royaumedeole.fr/informatique/plugin-mach3-pour-vfdhuanyang/

3

General Mach Discussion / Re: Number pad Pendent

« on: December 08, 2011, 09:32:16 AM »

hi Tony
watch this video it can help you

http://www.youtube.com/watch?v=rQVh8vYh1pI
Tulip

4

General Mach Discussion / Re: touch probe file converting to g gode??

« on: December 01, 2009, 08:46:18 AM »

if you go to the Config menu then Ports and Pins then Mill Options then digitizing you will see a box that if checked may put X Y and Z letters in for you
good luke for me is wrok very well
tulip

5

General Mach Discussion / Re: Re: digitize wizard

« on: January 07, 2009, 03:47:42 PM »

fantastic it works very well
thank you all

6

General Mach Discussion / Re: digitize wizard

« on: January 05, 2009, 01:55:37 PM »

Hello
My name is Pierre
I am newbie on  Mach3
I am searching more information about the wizard digitize hen I file my all coordinated but without the X on Y and Z on each line of gcode
thank you for your help
PS. excused my English
Tank you