Hello Guest it is March 28, 2024, 04:52:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Verell

Pages: 1
1
General Mach Discussion / Re: Mach Workshop at Cabin Fever Expo
« on: January 20, 2009, 12:39:04 PM »
The seminar was great. I got a chance to meet a lot of great people, put faces to names and learn a lot.
I want to thank all involved and I hope I do not leave anyone out; Ron, Brian, Scott, Dave, Craig from Smooth Stepper, Tom
Regards, Len :)

+2
Being totally new to CNC & Mach, I felt as if I had a funnel in each ear & they were pouring knowledge in. Unfortunately I reached mental saturation about mid-afternoon Saturday. Just couldn't absorb it all as fast as it was coming. Still, a great workshop & thanks to all!!!

2
Ahh, that explains it,  I did put the Holiday Inn into Yahoo, missunderstood where Cabin Fever was being held.
I've corrected the street. Blame Yahoo as they gave me the 'south'.

I'm still interested in sharing riding/driving(see earlier post) from MA.

3
I'm in Groton, MA, just south of Nashua,NH. It's a 7 hour drive from here. Was wondering if anyone would like to meet up in MA & share a ride/driving?

N4NV,
I just booked at the Roadway, thanks for the tip.

BTW, Yahoo maps shows it as being 3.9 miles/13 minuites away. In case anyone else is interested, here's their info:

Roadway Inn York
(717) 843-8974
132 North George Street York, PA 17401

If you have TravelValuesPlus, book from the choice hotels website & TVP discounted rate is: $42.39/night!

Pages: 1