Hello Guest it is August 15, 2020, 01:59:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - illmakemyown

Pages: 1 2 »
1
General Mach Discussion / Re: Can I buy a manual for Mach3
« on: May 21, 2012, 12:06:44 PM »
I went to kinkos yesterday and printed out manual.

2
General Mach Discussion / Can I buy a manual for Mach3
« on: May 20, 2012, 02:15:56 PM »
Can I buy a paper Manual for Mach3? If so where at? Thanks

3
General Mach Discussion / Re: Mach3 Download Question
« on: May 03, 2012, 09:33:44 PM »
IT'S ALIVE !!!!!!! It's moving. Thanks everyone.

4
General Mach Discussion / Re: Mach3 Download Question
« on: May 03, 2012, 02:19:18 PM »
Cool thanks a lot I'm going to try that in a bit thanks again

5
General Mach Discussion / Re: Mach3 Download Question
« on: May 03, 2012, 12:48:49 PM »
I'm going to do that right now thanks, but I have seen people show like a virtual jog handel on there Mach3 software how do I get that handel to open on my program or where on the program do I have to go to jog the axis's? Thanks

6
General Mach Discussion / Re: Mach3 Download Question
« on: May 02, 2012, 10:19:50 PM »
How do I make all of my axis move then? Thanks

7
General Mach Discussion / Mach3 Download Question
« on: May 02, 2012, 09:42:36 PM »
I finally got around to getting my Denford Micromill 2000 all wired up to my Gecko G540 (its only been like 3 years since I started to do this LOL) and i have a quick question in regards to the Mach3 sample download. Is there anyway I can jog my axis with the sample software, or do I have to buy the full version? I just want to make sure I have everything connected right before I go ahead and buy the full version. Thanks

8
General Mach Discussion / Mach 3 and Geckodrive G540
« on: May 05, 2009, 12:05:54 AM »
I just bought a Geckodrive G540 so I can convert my Denford Micromill 2000. I plan on buying Mach 3 but I don't know if I would need the Add Ons for the software, I am going to be using Mastercam to draw my parts. So my Question is What should I buy? Thanks

9
General Mach Discussion / Re: Denford Micromill 2000, Denford Microlathe
« on: December 30, 2008, 10:13:50 PM »
Thanks for the info, I was thinking the same thing, Denford is sort of a pain in the butt to deal with, where did you buy the components to convert yours? Thanks

10
General Mach Discussion / Re: Denford Micromill 2000, Denford Microlathe
« on: December 27, 2008, 03:10:27 AM »
Thanks for the info, but if i convert my machine to run with these boards, can i use Mastercam version 7 or Mastercam version 9 to run the machine, I have this software already.
Thanks

Pages: 1 2 »