Messages

1

General Mach Discussion / X-Box 360 Controller and Spindle

« on: January 01, 2009, 08:40:24 PM »

I was wondering if anyone else had a problem with the spindle motor turning off when the X-Box 360 controller automatically shuts down. It has happened only once but I have not had a line of code last that long until today.

Any help on this is appreciated.

Thanks
Michael

2

General Mach Discussion / PWM on spindle

« on: December 18, 2008, 10:31:18 AM »

I have a pmdx-106 to control my spindle direction and speed. Well the direction works just fine but everytime I try to inout a speed wether on the toggle button or on a "m" command, the computer beeps and says "setting PWM to minimum". Can anyone help?