Messages

1

General Mach Discussion / Re: MOTORS NOT TURNING !

« on: December 20, 2008, 11:16:24 AM »

Hello Henry, I'm having the same problem here, but only the x axis is not working. Everything was working fine until... nothing, i didn't change any configuration or (un)plugged anything. It just stopd...

2

General Mach Discussion / Re: Random stop at x axis

« on: December 19, 2008, 05:17:52 PM »

Hey hood! Does it make any difference? I saw here a guest saying he uses a pentium and works fine.

I'm home now, so i'll make the test tomorrow and post the results here!

Overload, i didn't connect the other computer yet, as soon as i do that, i'll run the tests!

3

General Mach Discussion / Re: Random stop at x axis

« on: December 19, 2008, 01:13:09 PM »

Ops, sry... you're right, it is a stepper,.

Does it make any difference if the same configuration is applied in the other computer (the one that works normally)? And the thing is that it must run with the best speed/acceleration because i work with production...

Still, I'll change the settings, and post the results!

Thanks!

4

General Mach Discussion / Random stop at x axis

« on: December 19, 2008, 07:22:00 AM »

Hello folks! I have read a lot of topics here and haven't found a solution yet. So, i decided to post and see if anyone can help me. The problem is that my CNC Router works fine in a AMD duo core, 2gb ram, and has this x axis problem with a intel quadcore 4gb ram. It sometimes jam for about a second, making a creepy sound of the motor forcing the movement and then again continue moving normally until it happens again.

I saw in other topics some similar problens, and the solutions taken. Unfortunatelly none of them solved mine. Changed the pulse, the CV, made the driver test. Is there anything else i can do?

Ps: sorry for the bad english (brazilian, and i'm not a indian lol)