Hello Guest it is January 28, 2021, 10:20:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tweeter

Pages: 1
General Mach Discussion / Re: Question about db25 hookup
« on: December 18, 2008, 06:09:55 PM »
Thanks for the help guys. I never hooked anything on a printer port I was thinking better to sound stupid than kill a 1000.00 dollar pc. Thanks again

General Mach Discussion / Question about db25 hookup
« on: December 18, 2008, 12:31:58 PM »
Hello my question is should I hook up my StepGenie IC diy board to my pc, because I am reading 5v coming out of the step input and dir input. I hate to sound so noobish but we all have to start somewhere. I did ground the inputs to see what will happen and I got motion from the stepper. But before I go ahead and break my pc I wanted to check here.

Pages: 1