Messages

1

Third party software and hardware support forums. / 24000 RPM to = 10 vdc from the Campbell combo board

« on: February 03, 2008, 11:36:03 PM »

Hey Guys.
I need 24000 RPM to = 10 vdc from the Campbell combo board. At this point 13000rpm = 10 vdc.  What do I change? Is this done on the new spindle config page?
Thanks. Russ.

2

VB and the development of wizards / Re: cancel feed rate over-ride in ATC macro

« on: December 22, 2007, 01:34:45 PM »

That did it. Thanks very much for your help.
Russ.

3

VB and the development of wizards / cancel feed rate over-ride in ATC macro

« on: December 18, 2007, 06:51:47 PM »

Festive greetings to everyone.
I have a tool change macro working on my router. I need to cancel the feed rate over ride at the beginning of the macro before it executes the first move of the sequence. I can not seem to get this to work. I have tried to use oem code 201 which is feed rate over ride off. Is this a suitable approach? Can you give me an idea how I reference this with script? I have not seen any macros where the feed rate over ride is cancelled. I would have thought that this is commonly done.

Thanks for your help. Russ.