2
« on: April 07, 2024, 07:21:49 PM »
Hi Andy
I did some messing around with the 5327 ver and smoothstepper ver 309
I finally got the m6 to work with the mdi and gcode file.
But i am having some strange results, on the m6 lines. its seems to want to pick the next tool and not the one on the m6 line..
I a run the gcode it want to pick the the next tool change from the gcode, not always the m6 line it stops on so if the first m6 line looking for tool 13, and the next m6 line in the gcode has t4 on the m6 line it picks tool 4 as the tool change on the first m6 t13 line instead of t13 and the code will excite ok for here till it gets to the next m6 t4 now it thinks that t4 is already in the spindle so it doesn't stop and wait for the tool change.
Not sure if i am making any sense..
I am using the m6 macro that mach4 installed when i installed it and made no modes to it, and i am using the wx4 screen..
other than it seeming to be the wrong tool to change to the code will run and do its functions but without stopping for a tool change sometimes.
This is the first 3 tool change's in the gcode file if you see anything there that would cause the problem.
[
(SLICEHDMOUNTSPOTDRILL)
(EFFECTOR SLICE HOTEND MOUNT)
(T13 D=0.25 CR=0. TAPER=90DEG - ZMIN=-0.0394 - SPOT DRILL)
G90 G94 G91.1 G40 G49 G17
G20
(SPOTDRILL)
M5
T13 M6
S3000 M3
G54
M8
G0 X0.7162 Y0.0877
G43 Z0.689 H13
Z0.2953
G98 G81 X0.7162 Y0.0877 Z-0.0394 R0.1969 F6.
X0.374 Y-0.0878
Y-0.4815
X-0.374
Y-0.0878
X-0.7184 Y-0.1652
G80
Z0.689
(SLICEHDMOUNTLDXHOLES)
(EFFECTOR SLICE HOTEND MOUNT)
(T4 D=0.1339 CR=0. TAPER=118DEG - ZMIN=-0.6693 - DRILL)
(LDX HOLESDRILL)
M9
M5
T4 M6
S3000 M3
G54
M8
G0 X0.374 Y-0.0878
G43 Z0.689 H4
Z0.2953
G98 G83 X0.374 Y-0.0878 Z-0.6693 R0.1969 Q0.0138 F17.2
Y-0.4815
X-0.374
Y-0.0878
G80
Z0.689
(SLICEHDMOUNTLDOHOLES)
(EFFECTOR SLICE HOTEND MOUNT)
(T17 D=0.0984 CR=0. TAPER=118DEG - ZMIN=-0.6496 - DRILL)
(LDOHOLESDRILL)
M9
M5
T17 M6
S3000 M3
G54
M8
G0 X-0.7561 Y-0.1327
G43 Z0.689 H17
Z0.2953
G98 G81 X-0.7561 Y-0.1327 Z-0.6496 R0.2953 F4.7
X0.6785 Y0.1201
G80
Z0.689
/code]
thanks Gary