Hello Guest it is March 29, 2024, 04:50:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Carver

Pages: 1
1
Thanks Brett!

That was exactly  what I needed.     Phill

2
Running Mach3 to a Vortech router. (Stepper motors)

 Straight cuts, circles and arcs all cut pretty decent, but compound curves (most of my work) cut painfully slow and "jerky".

Converting compound curvess to arcs and tangent line segments speeds the process up, but with hundreds of segments, the acceleration and deceleration appear to be applied to each and every segment in spite of continuity.

I have done some trial and errror setting accel and decel, but with no apparent affect.

I have also tried CV mode with no apparent value.

I suspect I am just overlooking something simple. Any and all suggestions appreciated.

Thanks in advance, Carver

Pages: 1