Hello Guest it is March 28, 2024, 05:16:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cbreitzman

Pages: 1
1
General Mach Discussion / Re: Can someone help with this error
« on: January 25, 2014, 01:10:49 PM »
Gerry,
         Can you tell me what the proper method for uninstalling the screenset is?
thanks

2
General Mach Discussion / Re: Can someone help with this error
« on: January 19, 2014, 06:25:21 PM »
You mentioned earlier that there was a proper way to uninstall it, can you help me out with that?

thanks

3
General Mach Discussion / Re: Can someone help with this error
« on: January 19, 2014, 05:52:33 PM »
Now the error actually shows up for every screenset I tried.

4
General Mach Discussion / Re: Can someone help with this error
« on: January 19, 2014, 04:07:15 PM »
Not sure what MSM screenset is and I have not uninstalled any of the screensets. I have been using MachBlue probing big tex ver 3. I was switching back and forth between sets to see if that was where the error was coming from.

5
General Mach Discussion / Re: Can someone help with this error
« on: January 19, 2014, 04:01:59 PM »
Thanks for the reply, I am running version R3.043.066. Sorry about the picture, took it with my cell phone and did not change the resolution. I've posted before, but never a picture....I'll learn!

6
General Mach Discussion / Can someone help with this error
« on: January 19, 2014, 03:36:50 PM »
I have a fully licensed copy of Mach3 and recently installed the latest updates(a week ago). I ran the machine several times after that with no issue. Today I did a couple of jobs and then this error appeared when I clicked cycle start. The machine ran normal after clicking OK on the error. The message appears after the cycle is complete as well. Attached is a picture (I hope) of the error. Thanks in advance.
ERROR, #Expand File not found at:

Chuck

7
General Mach Discussion / Re: step rate
« on: July 18, 2009, 04:24:21 PM »
Pulse with 3, kernal speed 25000, HbbyCN boad with nema23 305oz motors. Thanks for taking the time to help.

cb

8
General Mach Discussion / Re: step rate
« on: July 18, 2009, 04:03:06 PM »
I have tried many different combinations and still have a stalling issue. There is no mechanical prolems, and the stalling happens a random times during a run. Sometimes as long as thirty minues in.

9
General Mach Discussion / Re: step rate
« on: July 18, 2009, 03:53:23 PM »
The X-axis stepper is stalling, another forum told me to reduce the step rate and I'm not sure how to do it.

10
General Mach Discussion / step rate
« on: July 18, 2009, 01:12:37 PM »
How do you change the tep rate in Mach3?

Pages: 1