1
General Mach Discussion / Re: Newby with a question about Spindle Step/Dir setup
« on: October 19, 2008, 01:35:52 AM »
I am using the Spindle drive step/direction and not the axis drive. My axis drives do accel and decel nicely like they should. The spindle motor will accel just like I have it set up in the motor tuning and I thought should decel just the same but that is not the case. Another thing that happens when changing spindle speed from lets say 1000rpm to 500rpm is that is immediately changes and when going from 500rpm to 1000rpm it will accel nicely up to the new speed.