Messages

1

Galil / Re: Mach3 + Galil

« on: December 23, 2006, 03:42:24 PM »

GenGuy, download the term software form Galil to check that you have the galil registerd in the system. once you have it set up and running in there software I will send you the newest plugin that I am working with

Excellent, thanks Brian. I have sent an e-mail to you.
I installed the galil driver "dmcdriverdll02" and the plugin initializes correctly now.
As soon as I get a chance I'll connect to the controller and see if I can get it work.
Thanks for all your efforts!

Update Jan. 17, 2007:
I never did get this connected to the control. Not through any fault of the software though.
The Galil card is buried under a PC104 computer and uses the PC104 ISA interface to communicate, so I can't connect to the controller directly. It turns out that the PC104 computer doesn't come close to the requirments to run Mach3 directly on it. The machine needs to retain it's current functions so I can't risk further experiments with it. So my fun with this Galil has come to an end for now.

Thanks again Brian for your help.

Best of luck to all those trying to tame a Galil!

2

Galil / Re: Mach3 + Galil

« on: December 10, 2006, 02:43:43 PM »

Hi everyone!

I am also looking for a Galil solution.
I downloaded Mach3 R2.0.024 and the Galil IO plugin and am getting these errors:




Am I missing something?
I am hoping to get this working on a DMC1240.
If I can get Gcode to run on it, I will gladly purchase the software.