Hello Guest it is April 01, 2020, 08:13:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gage1049

Pages: 1
1
General Mach Discussion / Re: Mach2 V. mach3 help
« on: October 11, 2008, 03:09:02 PM »
Thanks Hood,

I did install the driver and did the driver test. It was almost a flat line which is good. The port for my lpt 0378 and I double checked it in device manager. I even changed it to a different port and changed the resource, no luck there either. My port and pin setup is exactly as I did in mach2 and it works. Just don't know why mach3 is giving me a hard time.

2
General Mach Discussion / Mach2 V. mach3 help
« on: October 11, 2008, 01:41:17 PM »
First post on the forums and I have a problem I just can't seem to figure out.

I loaded Mach3 without problem setup and motors did not respond. Went through all of the troubleshooting and still nothing. I deleted mach3 and loaded mach2 and it worked perfectly. Motors respond and run great. Any ideas on why mach3 will not work? Thanks for any input.

Pages: 1