Messages

1

LazyCam (Beta) / Re: trouble posting code

« on: October 16, 2008, 11:06:22 AM »

Rich and whoever else wants to reply,

I have tried to reinstall lazycam as well as checked the location after closing the location and reopening all to no avail.  Anymore suggestions would be great.

Thanks

2

LazyCam (Beta) / Re: trouble posting code

« on: October 15, 2008, 03:26:31 PM »

i will try,

Thanks

3

LazyCam (Beta) / Re: trouble posting code

« on: October 15, 2008, 02:36:37 PM »

Dave,

That is exactly what I am saying.  I hear ya and I have tried changing it to see if it is a conflict with the folder name in which it is to post the code.  It still didn't show up. 

Keith

4

LazyCam (Beta) / trouble posting code

« on: October 15, 2008, 11:56:51 AM »

I am having trouble posting code via lazy cam.  When I use the "post code" the program says that "posting file complete", but there is no existence of a posted code.  On another file that I have posted the code, Lazy cam says where the file has been posted.  Anyone have an answer for this.  How about a suggestion.

5

General Mach Discussion / Re: pwm base

« on: October 05, 2008, 10:50:14 AM »

I am not at the machine right now but will be there later this evening.  I will attach a file if i haven't had any sucess.  Thanks

6

General Mach Discussion / Re: We are having difficulty setting up the home switch settings.

« on: October 05, 2008, 10:24:14 AM »

educate me please.  We have a sensor on the gantry that I am assuming is the home/limit switches.

7

General Mach Discussion / Re: pwm base

« on: October 05, 2008, 10:22:38 AM »

The PWM is greyed out, and I am not quite sure what it does.  Vortech shows this as a setting, if it is of no consequence then I won't let it bother me at this point. As for what version I am using, it is 3.041. 

I appreciate your response, thanks

8

General Mach Discussion / pwm base

« on: October 04, 2008, 11:22:14 PM »

The manufacturer of our router table suggests that the pwm base be set at 7.  We are unable to alter this setting and the default setting of 5 will not allow itself to be altered.  Is there another place to alter this setting other than under ports and pins spindle setup?

9

General Mach Discussion / We are having difficulty setting up the home switch settings.

« on: October 04, 2008, 11:16:59 PM »

We are new at Mach 3 and cannot seem to find the toggle to turn the m1, m2 and m3 home toggles on and off that the tutorial keeps asking us to do.  Is there a hot key?