Hello Guest it is September 16, 2019, 09:11:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - snyper27

Pages: 1
1
General Mach Discussion / Re: Sanyo Denki BL Super servos
« on: May 19, 2007, 01:49:39 AM »
cory,

pleeease.....what where the terminals labeled on your drive that the step and direction wires connected to ? (cw+/ccw+)?

Grounded the rest?

2
General Mach Discussion / Re: Sanyo Denki BL Super servos
« on: May 15, 2007, 08:58:27 PM »
I have some stepper drives with the same CW/CCW interface...

I also would like to know how to utilize MACH 3 with them....

...since MACH 3 only seem to allow one step, and one direction, per axis...

don't want to attempt slaving to fool it into driving one axis...

3
General Mach Discussion / Re: Sanyo Denki BL Super servos
« on: May 15, 2007, 08:53:45 PM »
Dennis,

Thanks for your assistance on the zone..

What part numbers/schematic do I need to make this?

Are there premade ones?

I have 9 of these drives that need these....

Regards,
Justin

4
General Mach Discussion / Re: MACH3 on clients computer
« on: May 12, 2007, 07:36:11 PM »
Thanks Hood :)

5
General Mach Discussion / MACH3 on clients computer
« on: May 12, 2007, 03:47:51 PM »
I am making a machine for a client.

I am want to include a PC with MACH 3 on it.

Can I purchase ANOTHER license of MACH 3, licensed to HIS NAME, have him take posession of it?

He wants the system "ready to go", and knows nothing about PCs.

Thanks guys,

Regards,
Justin

Pages: 1