Hello Guest it is April 01, 2020, 08:52:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - servant74

Pages: 1
1
Howdy,
  I am finishing up my desktop CNC rig based on HobbyCNC plans.  I would prefer to use open source software
(like EMC2 under Ubuntu) but have had some significant patience issues on my part.  I plan on giving Mach a try,
if it works like I think I am seeing, I may have to get over my dislike for anything Gatesian (based on his Open
Letter to Computer Hobbyists from the 1970's - dinosaurs like me have long memories) and just get the job done.

Getting into CNC as a hobby. ... Jack in TN (near Nashville)

Pages: 1