1
General Mach Discussion / Re: controller type for SolidCAM
« on: September 24, 2008, 04:40:32 PM »
Hello,
Does anyone has a Pre and Post Processor for Solidcam using MILL_&_TURN operation
as a machine_type that produce G-Code for Mach3?
The Mach3.mac and Mach3.gpp files that is out there are for MILLING operation only.
Maybe some sharp people out there can help me modified the Mach3.mac and Mach3.gpp files
to work in MILL_&_TURN operation. (The mac_axes is XZC)
I have tried to learn the gpptool-example already but I still don't have
a clue how to modify the files. Sorry, I am not a programmer.
I would appreciate with any help.
Does anyone has a Pre and Post Processor for Solidcam using MILL_&_TURN operation
as a machine_type that produce G-Code for Mach3?
The Mach3.mac and Mach3.gpp files that is out there are for MILLING operation only.
Maybe some sharp people out there can help me modified the Mach3.mac and Mach3.gpp files
to work in MILL_&_TURN operation. (The mac_axes is XZC)
I have tried to learn the gpptool-example already but I still don't have
a clue how to modify the files. Sorry, I am not a programmer.
I would appreciate with any help.