Hello Guest it is March 28, 2024, 06:40:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Cooper

Pages: 1
1
General Mach Discussion / Re: Works in KCam, Not working in Mach3
« on: March 01, 2007, 02:16:48 AM »
Dear Brian,

I bought my driver via Ebay. Here is the link :

http://cgi.ebay.com/4-AXIS-CNC-ROUTER-OR-MILL-STEPPER-MOTOR-DRIVER-BOARD_W0QQitemZ230098501074QQihZ013QQcategoryZ78196QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

This driver is based on Allegro A3977 driver chip and it has 6N136 Optocoupler. As you know 6N136 is 1 Mbit/sec opto and quite fast to control signals. I don't know what the problem is but i can use it in Mach3 trial :)

Cooper

2
General Mach Discussion / Re: Works in KCam, Not working in Mach3
« on: February 28, 2007, 08:55:48 AM »
Dear All,

I solved my problem with Sherline 1/2 option.
Thank you for your kind interest.

Cooper

3
General Mach Discussion / Re: Works in KCam, Not working in Mach3
« on: February 28, 2007, 07:17:05 AM »
Hello Brett,

Sorry, i forgot to add. Here it is :

http://rapidshare.com/files/18691175/Mach3Mill.xml.html

I tried to add file content here but my message exceeds max allowed length.

Cooper

4
General Mach Discussion / Works in KCam, Not working in Mach3
« on: February 28, 2007, 05:28:16 AM »
Dear All,

I bought my cnc controller yesterday and i connect everything as in manual. The board works very well in Kcam (Kcam is explained in manual and i configured this program works very well). But i would like to buy Mach3 and so i need to configure it for Mach3. I took this ss from related softwares :

Mach3 : (Not Working)


KCam : (Works well)


So, what's the point? What is wrong with these configuration?

TIA

Cooper

Pages: 1