1
General Mach Discussion / Re: Six axis setup
« on: September 22, 2008, 02:14:12 PM »
I had issues with my parallel ports in that I couldn't use my on-board port as port one and my PCI add on card as port two. I had jog issues, ports not working, etc.
In my efforts to diagnose my pci card port, I swapped my on board parallel port to LP2 and my PCI port to LP1. I also modified the entries in Mach to reflect the changes.
In doing this, all worked as it should! I swapped every thing back to make sure I wasn't dreaming this and it was back to the same old stuff of not working. Swapped it back and all is well.
Not sure if this would be related.
In my efforts to diagnose my pci card port, I swapped my on board parallel port to LP2 and my PCI port to LP1. I also modified the entries in Mach to reflect the changes.
In doing this, all worked as it should! I swapped every thing back to make sure I wasn't dreaming this and it was back to the same old stuff of not working. Swapped it back and all is well.
Not sure if this would be related.