1
General Mach Discussion / Re: Converting Sherline Linux/EMC to Windows/Mach3
« on: September 22, 2010, 01:46:09 PM »
Hi Sherlline 2000 Mill
Iv also been running EMC2 Successfully but would like to run Mach3...
Where are the ports and pin settings for a Sherline 2010 Mill standard setup? Iv emailed Sherline.
There seems to be little on the net. I wonder what iv missed.....not that Sherline tick box though on Mach3 screen I got that.
I use the printer cable but that is not a prob. I'm using a separate computer for xp/Mach3 and have ubuntu Linux for emc2 which works...
Just aside note..
There are no limit switches on the Sherline Mill as its construction and small size allows survival with out them. I know ... iv survived.
Soft limits sound a good idea..
HELP a list of ports and pins or screen shots would be great..
Iv also been running EMC2 Successfully but would like to run Mach3...
Where are the ports and pin settings for a Sherline 2010 Mill standard setup? Iv emailed Sherline.
There seems to be little on the net. I wonder what iv missed.....not that Sherline tick box though on Mach3 screen I got that.
I use the printer cable but that is not a prob. I'm using a separate computer for xp/Mach3 and have ubuntu Linux for emc2 which works...
Just aside note..
There are no limit switches on the Sherline Mill as its construction and small size allows survival with out them. I know ... iv survived.
Soft limits sound a good idea..
HELP a list of ports and pins or screen shots would be great..