Hello Guest it is March 28, 2024, 04:44:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cfm

Pages: 1
1
General Mach Discussion / Mach 2 Height Control
« on: November 22, 2005, 09:35:18 PM »
I can't seem to adjust the height at which the plasma cutter is, moving it left/right or up/down is fine, but i need to lower it a bit, and can't seem to do it.

can anyone help?

thanks

Pages: 1