Hello Guest it is March 29, 2024, 03:11:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - erkiwi

Pages: 1
1
General Mach Discussion / Stop and start spindle using Mach 3
« on: November 03, 2008, 11:29:49 PM »
Hi .
I want to start and stop my spindle from G code program using  mach 3 mill , I have a C11 breakout board from cnc4pc and the spindle motor is connected from that  relay  Pin 1. What do I need to set up in Mach 3 spindle set up to get this to work.
Regards
Eric :)

2
General Mach Discussion / Re: Start and stop spindle from mach 3
« on: August 24, 2008, 04:24:54 PM »
I am just worried that if the motor burns out or the drive belt breaks when I am not near the machine , the program will keep running and stuff up the job.

3
General Mach Discussion / Re: Start and stop spindle from mach 3
« on: August 21, 2008, 06:55:40 PM »
The motor is 1000w two speed ,selected with a two speed switch
regards Eric

4
General Mach Discussion / Start and stop spindle from mach 3
« on: August 21, 2008, 05:33:04 PM »
Hi.
I have mach 3 running through a C11 breakout board from cnc4pc.I currently start and stop the spindle manually,what I would like to do is turn spindle on and off through mach 3,and also stop the maching program from running if the motor stops,how can I do this?The motor is a 240v DC but has 240v AC into the PCB board before converting to DC at the motor.
regards Eric

Pages: 1