Hello Guest it is August 15, 2020, 12:26:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - skimpro

Pages: 1
1
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 22, 2007, 10:10:03 PM »
Ok Its 2366324

2
Hi Don. I could not get the microkenitics drivers to work with Mach 3. I am working on using geckos to replace them. You should get a breakout board because all of the pins are different from Mach 3 to the drive rack. Also the transformers put out 86 volts which was to much for my nema23 motors, so I had to redo the drive rack. I am switching to Mach 3 for the same reason you are- the old software microkentics offers. By the way, the geckos make my motors run alot smoother and faster than they did with microkenetics. Let me know if you need more details.

3
General Mach Discussion / Driver test
« on: December 01, 2006, 11:27:01 PM »
I have been trying to get Mach 3 to work with my computer and gecko drives . I have checked everything I can think of and still can't get any motor movement. The one thing that seems odd is when I run a driver test a message comes up that says "Could not locate missing vectors". When I close the window and run the test again, the test will then work. Could this be a clue as to why I can't get anything to work?

4
Third party software and hardware support forums. / Microkinetics and Mach3
« on: November 11, 2006, 11:02:38 PM »
I have microkentics cnc and would like to switch the software to Mach 3. I have messed around with this for a few days and can't seem to get it to work. Has anyone been able to do this?

Pages: 1