Hello Guest it is November 21, 2019, 07:07:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - altonj2008

Pages: 1
1
Nevermind for now. I restarted install and driver loaded.  Thanks, Alton

2
General Mach Discussion / Newbie Locked up during installation of 3.041
« on: August 15, 2008, 11:40:54 PM »
Please help. This is my first attempt to install Mach3. I'm installing R3.041 as required to run with Smooth Stepper. When prompted to install mach drivers, Vista gave me a trust warning. I opted to install anyway. Now, the installation has been at "Please wait a moment" for quite some time. Does anyone have any advice?

Pages: 1