Messages

1

General Mach Discussion / Re: edit button scripts

« on: March 09, 2024, 04:41:43 AM »

thanks

2

General Mach Discussion / Re: edit button scripts

« on: March 08, 2024, 12:43:36 PM »

G00 Z .100
G00 X0 Y0

FOR ONE BUTTON
 
GOO Z .100
G00 X-.3415
G00 Y -3.140

FOR ANOTHER BUTTON
NEXT BUTTON SAME AS 2ND ONE WITH POSITIVE INSTEAD OF NEGATIVE MONVES

3

General Mach Discussion / edit button scripts

« on: March 08, 2024, 12:48:46 AM »

1...installed camera.. use button "set variable position"  "go to variable position" and "stop teach"  wrote my code,,when i run, i get compile error  syntax error
2... i have new buttons installed in millbitmaps folder, dont  know how to post them in place of the above mentioned buttons,, the new one are jpeg files

4

General Mach Discussion / Re: windows

« on: May 06, 2020, 08:34:55 PM »

i dont see my answer but was trying to thanks you
larry

5

General Mach Discussion / windows

« on: May 06, 2020, 07:51:28 PM »

computer crashed, gotta buy new one, or refurb, running windows 7 Hp,, my questions is what windows version should i look for. ive heard of problems with 10  how about windows xp professional??  if i need 7 hp ill look until i find it,,only experience with this was i found out windows 8 sucked  bty, im using parralell port

6

General Mach Discussion / Re: Cam generated line numbers

« on: December 30, 2018, 07:34:32 PM »

Thanks Craig.  I haven’t used numbers in so long. I forgot.

7

General Mach Discussion / Re: Cam generated line numbers

« on: December 30, 2018, 07:02:13 PM »

There is no n there

8

General Mach Discussion / Cam generated line numbers

« on: December 29, 2018, 07:26:53 PM »

When I generate g code in bobcad Mach 3 treats the numbers like bad code?

9

General Mach Discussion / Re: moving mach3

« on: November 28, 2017, 07:44:09 PM »

My bad  I have 1 profile. I thought my machining programs were xml files. Those are what I'm looking for

10

General Mach Discussion / Re: moving mach3

« on: November 28, 2017, 07:43:35 PM »

My bad  I have 1 profile. I thought my machining programs were com files. Those are what I'm looking for