Hello Guest it is March 29, 2024, 02:11:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jrlifter

Pages: 1
1
I am using Mach3.  I primarily use a 2ghz Inspiron laptop with 1gig ram.  I have 4 other destops in the room and have tried them as well with the same results.  The diagnostic utility does show my signal is pretty dirty, but I don't understand why it would clean up and work great just by switching the page within Mach3?   :-\

2
Whatever I set the jog rate to is what they travel.  If I set it for step then they step by the set inc. also.  If I set it for a .2 step the axis may loose 2 or 3 steps in that distance, but if I do the same on the Diagnostic page it steps perfect every time.

3
 ???

Mach 3 looses steps like crazy when on the Program Run page and the axis are jogged.  When I go to the Diagnotic page and move around they are smooth and never miss a beat.  This is on a Taig mini-mill, by the way.   Any ideas?

Jeff

Pages: 1