Hello Guest it is March 29, 2024, 06:53:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - yngsfan

Pages: 1
1
Mach3 and G-Rex / Re: [MACH3 with G100] ecode=777, ecode=790, ecode=813
« on: August 11, 2008, 12:49:34 AM »
I have seen the topic. But...I can't understand. What is rabbit?
He said "new rabbit". what means it?
Is it some plugin? or firmware?

Thanks for your kindness and reply. ^^
- Kris-

2
Mach3 and G-Rex / Re: [MACH3 with G100] ecode=777, ecode=790, ecode=813
« on: August 07, 2008, 05:59:03 AM »
I tried with router.
But Grex still shows me "ecode=777"

Please~~~ Somebody help me~~~!!! T.T

3
Then I have to buy a router... Ahhhh...
OK... I'll try...Thanks very much! ^^

4
Thanks brett!!

Then I got right firmware and plugin as the manual. the screen shot was matched with the manual.
And....You mean I have to connect Grex through router?

-Kris-

5
Thanks Brett!!

But...
Even Grex isn't connected to the net, but I can download the firmware and upload it, isn't it?

Please let me know which plugin and firmware is right one.

Best regard.

^^

6
Hi Brett!

Oh! you checked my topic so fast! Thanks!!
I reply your question as following.
Please let me know what I have to do.

1. My computer is not connected Internet.
2. GREX directly connected PC with crossover cable.
3. Computer's IP adress is 192.168.1.100. And Gres's IP adress is 192.168.1.10.
4. I have read the manual so many time...T.T And I did as the manual so many time...T.T

Please help~~~!!

Please~~~~~

Best regard. ^^

7
Mach3 and G-Rex / [MACH3 with G100] ecode=777, ecode=790, ecode=813
« on: July 29, 2008, 03:19:28 PM »

 Dear all G100 user!

 Hi! I'm Kris.

 I'm using MACH3 with G100. And I have some problem.

 First I can launch firmware load when Grex shows me red light.
 And I can ping Grex always. 0% loss. So I'm sure I have static IP adress.

 But after motor tuning in Mach3, I always see error message as attached file.
 I did searched all topic about "ecode=777", "ecode=790" and "ecode=813".
 And I tried all firmware and plugin I can get. (But I'm not sure I have right...)


 Does anybody know about this problem?

 Please help me~~~  ;)

 

Pages: 1