Hello Guest it is March 29, 2024, 02:13:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dfeeney

Pages: 1
1
General Mach Discussion / Re: Mach3 add on help
« on: July 29, 2007, 02:34:21 PM »
Yes I have clicked on the conversational button but it says that I am not licensed for it.  I have looked in the c drive and don't recall seeing a folder called Newfangled. I'll go out and see. I also saved the addon license to a new cd, I'll see if it works and let you know.

Dan

2
General Mach Discussion / Re: Mach3 add on help
« on: July 29, 2007, 11:12:23 AM »
No. I have this computer we use in the house for the internet etc. I am using another computer to run mach3 on my mill in the shop. What I need to do is copy the wizlic to a cd and then load it on the computer running mach3. I send it to C:\mach, but nothing happens and I don't know what else to do.

I have sent several emails to newfangled solutions but I get no response other than them saying It should be working.

I am just very frustrated at this whole thing because there is no one to talk to in person and the response times waiting for an email are just too long and at this point I am sick of waiting.

3
General Mach Discussion / Re: Mach3 add on help
« on: July 28, 2007, 03:05:47 PM »
I think I chose the wrong software and people to deal with. I tried the newfangled website and cant get on. I can't even send them an email.  There's no way to call either. I guess I am out 50 bucks.

Anyone know how I can contact them?

4
General Mach Discussion / Mach3 add on help
« on: July 28, 2007, 11:49:31 AM »
I just purchased the mach3 add-ons. I tried to open the .dat file but it says I need to go to control panel and create an association for it. I have no idea what to do. I know how to go to the file folder options in the control panel, but after that I am lost. I do not have mach3 installed on this computer so I need to save it and burn it to a cd and then load it to my computer that runs my mill.

Please help!!

Dan

5
General Mach Discussion / Cirlce Problem
« on: January 05, 2007, 03:39:57 PM »
Hello everyone. New here to the forum and Mach. Just retrofitted my mill. I am having problems with any type of circle. Looks like someone drew it by hand. Not at all symmetrical. I've tried adjusting backlash, it helped somewhat. I just don't know what else to look for.

Please help.

Dan

Pages: 1