Messages

1

General Mach Discussion / Re: Where did my setup file go?

« on: August 01, 2008, 03:46:37 PM »

High, tell me if don't load a license can't load the xml file?

2

General Mach Discussion / Re: Where did my setup file go?

« on: July 30, 2008, 07:06:08 PM »

no doesn't work may be becouse license don´t load yet

3

General Mach Discussion / Re: Where did my setup file go?

« on: July 30, 2008, 06:36:28 PM »

I am going to set a mach3 backup in other computer , i have the .xml file , do i save into the xmlbackup folder??? or what is the next step??
thanks a lot for help

4

General Mach Discussion / Re: Licence problem when upgrading

« on: July 25, 2008, 09:45:32 AM »

My situation is exactly as Saumur,I am going to try to explain, i have two machines working x and z ,the program is the same ithe profile is perfect in one, but in the other  is wrong.the second machine was set up last week , I made the normal calibration screw, backlash, and motor tuning, with the dial indicator (10mm stroke) move 1mm with jog and indicator was exactly, move 2mm was the same and so, but  if put to travel 5mm program g1 x5 each 1mm on the screenshow 1,06mm on the dial indicator, at 2mm on the screen the dial goes 2,12mm  and so, thats is the same in axe z, I hope anyone can help us

5

General Mach Discussion / Re: Licence problem when upgrading

« on: July 24, 2008, 09:15:04 PM »

Sorry Mr. I made a mistake, but the problem is as you can read

6

General Mach Discussion / Re: Licence problem when upgrading

« on: July 24, 2008, 08:44:43 PM »

Mr OVERLOADED may affect pulse width or debouncing time.

7

General Mach Discussion / Re: Licence problem when upgrading

« on: July 24, 2008, 02:22:24 PM »

may affect the width of pulse or debouncing time???

8

General Mach Discussion / Re: Licence problem when upgrading

« on: July 24, 2008, 12:02:09 PM »

Thanks Overloaded, the point is ,the calibration  servo, encoder, screw was setting in mm, that was checked with comparator and command jog and was ok. I thought everything ok for production but running a piece observe that both the x and z gain 0,06 per mm.
FMUR

9

General Mach Discussion / Re: Licence problem when upgrading

« on: July 24, 2008, 10:32:09 AM »

Saumur, i have the same problem, did you solve it?, please answer