Hello Guest it is March 28, 2024, 06:12:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ngocthanh03

Pages: 1
1
General Mach Discussion / Re: Reverse RUN problem in second pass
« on: July 31, 2011, 04:59:49 AM »
I have same problem, some one can tell me how to run reverse?

2
Thank your for your answer, but I don't understand your idea clearly!

I tried to modify the *.PST file, delete all "Z" in this file but the G code output always have a "G0 Z" command at the end of file, like this!

"
N285 M5 (Plasma Off)
N290 G0 Z60.0000
N295 M30

"
And the same question for the string "Plasma Off", i DELTETED it from *.PST file, but it always appear in G code file !
Please explain me more !
Thank you again !





3
Dear all,
I try to use Lazy cam to convert a dxf to a gcode file
I need a Gcode file with only X and Y axis ( don't need Z) to test, it very important. But I can't find where I can set this option ?.
 In Mach3 version 1.8x, I use import DXF, it has an option "No Z's Or S's", but in Lazy Cam, I cannot find this option !

Please guide me.
Thank all,

4
General Mach Discussion / Re: Mach3 via COM Port
« on: July 16, 2008, 04:12:21 AM »

All motors which I use is AC servo motor ( Mitsubishi and Yaskawa servo),  can  SmoothStepper controll servo motors?

Mach3 can use with USB Port ? how can I do that ?

Best regard !

5
General Mach Discussion / Mach3 via COM Port
« on: July 15, 2008, 09:38:45 PM »

I used Mach3 for a long time, but only with 2 LPT Ports.
Now, I want to use Mach3 to control more motor, pump and to solve Interference-proof problem.

How can I use Comp port, I heard about Homann Board, but, I don't know exactly which board I must buy ?

If I want to make a connect board via COM PORT by myself, there are any problems ? any schematic ?

Thank!

(Sorry for my English, I'm from Vietnam). ???




Pages: 1