Hello Guest it is March 28, 2024, 12:05:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jalessi

Pages: 1 2 »
1
Klaus,

Absolutely perfect, awesome work.

Thank you very much.

Jeff...

2
Klaus,

The cross-hair will not self center with the remember position enabled.

Jeff...

3
Klaus,

Ver 2.04 remembers its position however the cross-hairs do not center.

Thank you for your hard work,

Jeff...

4
Klaus,

Thank you for the fast reply.

Please keep us posted.

Jeff...

5
Klaus,

Is there a way to lock the screen position so it does not need to be reset every time Mach3 is closed and restarted?

Thank You

Jeff...

6
Scott,

Is the Plugin for Mach3 and the CNCbrain still in the works, or has it been canceled?

Thanks,

Jeff...

7
General Mach Discussion / Re: computer causing gorilla cnc glitch
« on: December 01, 2008, 04:22:20 AM »
Gorilla CNC User,

Adding an additional PCI parallel port wont stop the problem you are having.

What is causing the issue is intentionally built in to the BIOS and operating system.

It is not a matter of a defective P.C. or parallel port

First the BIOS on the motherboard polls the port or interrupts

Secondly Windows also polls the ports and interrupts during startup.

The only solution is to add a charge pump and wire it so the motor drivers are disabled when Mach3 is not running.

Jeff...


8
Where is the bitmap located for the modified1024.set

I would like to add a MDI to page 1 and need to adjust the background image.

Thank You

Jeff...

9
General Mach Discussion / Re: Auto run soft limits when Mach starts ?
« on: September 13, 2008, 08:52:18 PM »
Hood,

Thank you for the quick reply and answer.

We will try it and see which solution is best for our operation.

Jeff...

10
General Mach Discussion / Re: Auto run soft limits when Mach starts ?
« on: September 13, 2008, 08:50:54 PM »
Ger21,

Thank you for the quick reply and answer.

We will try it and see which solution is best for our operation.

Jeff...

Pages: 1 2 »