1
General Mach Discussion / Re: lpt problems
« on: December 06, 2008, 11:40:59 AM »
Hi Guys
found this thread while searching for a solution to a similar problem: i.e. a toggling input on pin 13 - I am using the Bob Campbell board V1.8 and am constantly getting a toggling pulse on input 13 on the diagnostics page, whether I have a switch connected to that input on the board or not - using it as an input with a remote switch to start cutting the file. I have tried 4 different computers and still get the same result. on some computers it starts toggling immediately and on others it only starts toggling once the drives are activated. - Pulling my hair out!!!
SPNAR - what board are you using?
found this thread while searching for a solution to a similar problem: i.e. a toggling input on pin 13 - I am using the Bob Campbell board V1.8 and am constantly getting a toggling pulse on input 13 on the diagnostics page, whether I have a switch connected to that input on the board or not - using it as an input with a remote switch to start cutting the file. I have tried 4 different computers and still get the same result. on some computers it starts toggling immediately and on others it only starts toggling once the drives are activated. - Pulling my hair out!!!
SPNAR - what board are you using?