Messages

1

General Mach Discussion / Re: Config Fonts Doesn't Appear to Work

« on: May 28, 2009, 11:10:19 AM »

It look like I am not the only with the same problem. I want to have the gcodes font "bold". Tried but the problem persists...

2

General Mach Discussion / Re: :1448

« on: September 19, 2008, 09:31:56 AM »

Hood, thanks for your reply. for postprocesor, I am using  a 4 axis listed in ArtCam,Axyz_Arc-INCH(*nc) dont see any 3 axis...maybe that could be the problem...not sure...

3

General Mach Discussion / :1448

« on: September 18, 2008, 04:24:47 PM »

When I open an *.nc file made with ArtCam, an entry in the Gcode listing right after the "%" simbol, starts with ":1448"...have to edit the code in order to run under Mach3. Is it a Mach3 or ArtCam problem?  After editing the code it runs fine without any apparent problem. Thanks for any clarification.

4

General Mach Discussion / Re: Lazy cam problems

« on: September 13, 2008, 08:53:52 AM »

When I draw arc, circles or curves in Corel Draw 12 and save them to .DXF, when it is opened with LazyCam, everything look like polygons lines...What it is wrong? Corel Draw or LazyCam? Thanks for any imput...

5

General Mach Discussion / Re: Version 2.63 vs: 3.00 vs:3.037

« on: August 01, 2008, 08:26:23 AM »

Upgraded from Mach2 to Mach3 with license but Mach3 still reads only 500 lines. How can I unlock the new version? Thanks

6

General Mach Discussion / Re: Mach3 no motors running

« on: July 12, 2008, 02:02:50 PM »

The Port Pins and Dir Pins were interchanged: X 3-2  Y 5-4 Z 7-6
Corrected" X2-3 Y-4-5 Z6-7

7

General Mach Discussion / Re: Mach3 no motors running

« on: July 12, 2008, 01:47:26 PM »

The original problem was that the Port Pins and Dir Pins were interchanged...

8

General Mach Discussion / Re: Mach3 no motors running

« on: July 11, 2008, 03:41:15 PM »

Finally have Mach3 working...thanks to everyone involved in the solution...

9

General Mach Discussion / Re: Mach3 no motors running

« on: July 10, 2008, 02:21:58 PM »

Included are my two  XML files

10

General Mach Discussion / Re: Mach3 no motors running

« on: July 10, 2008, 12:22:40 PM »

Finally "had" Mach3 running...the problem was the step pins and step ports were backward...ran for about 2 hours, went to lunch and when came back....you guess...Mach3 is not working, DRO's are not moving...double check the Motor outputs, they have not changed...going back to faithfull Mach2....!!!!
P.D. Hood, working on the XML files and send them to uou...thanks for you support.