1
Mach4 General Discussion / Re: Current Status of Mach4 Lathe
« on: February 16, 2015, 10:23:57 AM »
I am running a parallel port now to a CandCNC UBOB. From there it goes to the CandCNC router pack to drive the motors mounted on my lathe.
So it sounds like I will need a new external motion controller. Where can I get this? It would be great if I could find a Mach4 plug-and-play system. I'm not afraid to replace things with newer stuff to get a better overall system.
I don't have any custom scripts.
Thanks,
Kerry
So it sounds like I will need a new external motion controller. Where can I get this? It would be great if I could find a Mach4 plug-and-play system. I'm not afraid to replace things with newer stuff to get a better overall system.
I don't have any custom scripts.
Thanks,
Kerry