Messages

1

General Mach Discussion / Re: Mach3 going off course of cut

« on: December 09, 2006, 05:04:25 AM »

i think if you used lazycam to generate the code you didn't use autoclean

2

Show"N"Tell ( Your Machines) / Re: This is the machine i built

« on: November 19, 2006, 03:39:19 AM »

How much it will cost and where can i find one?

3

Show"N"Tell ( Your Machines) / Re: This is the machine i built

« on: November 18, 2006, 12:54:19 PM »

hi again

i foreget to ask you about the router!!!!!!!!
i am using a noisy router what is the best router for cnc?

4

Show"N"Tell ( Your Machines) / This is the machine i built

« on: November 18, 2006, 12:46:24 PM »

Hi all

i just built a big router table its working area 1500 mm for x and y axis 200 mm for z axis

i used two parallel large slide pars for x axis with two stepper motors and one for y axis and a small one for z axis

i want to thank art soft for mach3 it is a very nice software.

i did the open sign with vcrave demo it is the 1st work i do with my machine i got a good result 

but i faced a small problem with changing the tool bit i lost the zero hight so what is the best way to change the bit and maitain the zero hight?

see the pics

thank you
ialbazae

5

LazyCam (Beta) / Re: LC not included with mach3

« on: October 15, 2006, 09:24:00 PM »

I got it

thank for your help

6

LazyCam (Beta) / LC not included with mach3

« on: October 15, 2006, 10:01:41 AM »

hi

i downloaded mach3 1.84.002 and installed it when i check in the about window it says the version is 1.84001
also LC is not included with it
when i check in control panel for installed software i found the version of mach3 is 1.84.002

can any one explain that for me

thanks in advance
ialbazae