1
General Mach Discussion / Re: Scary depth
« on: August 05, 2007, 12:58:57 AM »
Gentlemen to all who answered my queries I thank you very much.
I worked through all the suggestions but it was the advice given by hood to set the steps per unit that did the trick. I managed to cut my business card holder and it wass great to see the machine do its 2mm steps into that beautifull ironbark.
I must be honest when I say I could not have done it without your help
Thank you again
Roly
Fro Batlow NSW
I worked through all the suggestions but it was the advice given by hood to set the steps per unit that did the trick. I managed to cut my business card holder and it wass great to see the machine do its 2mm steps into that beautifull ironbark.
I must be honest when I say I could not have done it without your help
Thank you again
Roly
Fro Batlow NSW