Hello Guest it is March 29, 2024, 07:37:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - euro

Pages: 1 2 »
1
General Mach Discussion / Re: g-code stops
« on: December 09, 2010, 12:24:17 PM »
im using a delta vdf i had my machine in storage for a year now ive set it up agian i had this problem from new and the tec couldnt figeur it out so he had me program the vfd so i was controlling the spindle ,a columbo, manaully and it worked but now its not i wired everything the same as before thanks guys

2
General Mach Discussion / g-code stops
« on: December 09, 2010, 01:11:10 AM »
hi guys have a problem,when i run g-gode wth the spindle turn on the code stops where ever no reason when i stop the spindle code runs perfect any ideas

3
General Mach Discussion / Re: z-axis problem
« on: July 01, 2008, 01:40:43 AM »
you were right brett the moter tunning was wrong thanks,everything is good now,back to relax,this is a great forum

4
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 11:36:49 PM »
brett also mention microsteps that i might have changed it where do you find the settins for the microsteps so i can also check that thanks

5
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 11:29:59 PM »
the problem started when i ran a file i got from the vectric forum could it had been what was in the g codes that changed the settins i know i didnt

6
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 11:08:29 PM »
thanks a lot for your help i got a hold of tec support and he thinks i must of typed in 2000 instead of 20000 steps under moter tunning ill double chek that in the morning agian thanks

7
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 09:25:20 PM »
no i dont have scaling dros is there somewhere in mach where i can scale from

8
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 08:51:20 PM »
i bet i do never notice ill have to run to the shop and see the people where i bought made there own screen so it is diferent than the default screens thanks for your help ill get back and post my findings

9
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 08:29:04 PM »
were in mach would a 10;1 issue happen

10
General Mach Discussion / Re: z-axis problem
« on: June 30, 2008, 08:26:00 PM »
sorry brett i see what you ment its a config issue

Pages: 1 2 »