Hello Guest it is October 07, 2022, 05:50:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bojan

Pages: 1
1
General Mach Discussion / Re: CharlyRobot
« on: October 15, 2006, 08:31:42 AM »
Hi zarzul,

do you find some answers for me?

lp
bojan

2
General Mach Discussion / Re: CharlyRobot
« on: October 12, 2006, 12:54:55 PM »
Thank you zarzul !!

Site is www.charlyrobot.com but machine is no more in production. Now is there new one charly2U. Almost same with bigger Z axis and with 4th axis, ATC....
I have stepper motors. I like MACH because I can make ATC and 4th axis myself is more programmable and.... I already send questions to charly support team but I don't know if this is right address (changing controller) . Can I send you pdf file (3.5MB)?

Thank you

bojan

3
General Mach Discussion / Re: CharlyRobot
« on: October 12, 2006, 12:20:09 PM »
Machine is connected via COM port. I have some drawings in pdf (to big for forum- 3.5Mb) If someone can help me pleas with this...
So - is possible to run MACH3 with this machine?
What information you need to know?

Thank you

Bojan

4
General Mach Discussion / Re: CharlyRobot
« on: October 12, 2006, 12:01:43 PM »
First I must say I almost have no clue about electric. There are some pictures of my cnc. I hope that someone can help me.
Nr. 1 / TOSHIBA inverter
Nr. 2/ controller and motor
Nr. 3/ CRA2
Nr. 4/controller with ?

5
General Mach Discussion / Re: CharlyRobot
« on: October 08, 2006, 11:52:05 AM »
No, this is not a robot - just a company name. www.charlyrobot.com
Ok. Next step is to open and look what is in.

Yes I know (now) you need more information. ::)

bojan

6
General Mach Discussion / CharlyRobot
« on: October 05, 2006, 04:57:10 PM »
Hi to all,

can I replace Gpilot (original CharlyRobot software) with mach3 on my CharlyRobot CRA2?
How can I start?

Any help pleas...


Thank You

Bojan

Pages: 1