1
General Mach Discussion / Re: Z Zero and TLOs - please help
« on: November 24, 2006, 02:36:34 PM »
ok, problem was solved after lots and lots of trial and error an ex-machinist friend of mine figured it out.
It turns out that I had a G91 (incrimental) instead of a G90 (absolute), this is what threw off the offsets.
If I actually knew mastercam x and could read g code better, I might have caught it myself :-)
Thank god for smart friends. Thanks for all the help.
It turns out that I had a G91 (incrimental) instead of a G90 (absolute), this is what threw off the offsets.
If I actually knew mastercam x and could read g code better, I might have caught it myself :-)
Thank god for smart friends. Thanks for all the help.