Hello Guest it is March 28, 2024, 09:37:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dierju

Pages: 1
1
Galil / Re: Galil to Mach
« on: September 07, 2010, 02:48:25 AM »
Steve,

thanks for your help. I have mapped the analog inputs, it works fine. Can I map the digital inputs like Galils IN1 to IN8 to mach?

Regards
Claus

2
Galil / Re: Galil to Mach
« on: September 06, 2010, 01:34:52 PM »
Hallo Kenny,

the MPG is ok over the secondary encoder channel. Bur how can I handle Galils analog and digital inputs in Mach. As I discribed I need AI1 and ANI for overwrite the feed and speed parameter and a combination of digital inputs IN1/IN2 for Axis selection, IN3/IN4 for resolutiion settings of the handheld and IN5-IN8 for setting cooling, Homing and so on. How can I map the AN and IN into mach. I can't find the variables into mach to read out the Galils ports.
Regards
Claus

3
Galil / Galil to Mach
« on: September 06, 2010, 04:19:21 AM »
Hallo,

I'am new with Galil and Mach. I would like to implement a handheld with MPG. I had seen the videos about Brains und had reading about it.. but can't use it without more informations...
Can somebody help me please with four brains. Thirst from Galils analog input3 to Machs feed override, second from Galils analog input4 to Machs speed override, third Galils digital input IN1+IN2(logical 1,1/0,1/1,0/0,0) to Machs Axis selection (X,Y,Z,A)  and Galilis digital input IN3+IN4(logical.....) to machs handwheel resolution (config/geneal config 0.1/0.01/0.001/0.0001/)
Cooling will be activated by IN5+IN6+IN7+IN8 logical (1/1/0/1)
Ref by logical (0/1/0/1)
I hope some can help me with the implementation.

In advance, thanks for your efforts

Regards
Claus

4
General Mach Discussion / Galil to Mach
« on: September 06, 2010, 02:34:17 AM »
Hallo,

I'am new with Galil and Mach. I would like to implement a hendheld with MPG. I had seen the videos about Brains und had reading about it.. but can't use it without more informations...
Can somebody help me please with four brains. Thirst from Galils analog input3 to Machs feed override, second from Galils analog input4 to Machs speed override, third Galils digital input IN1+IN2(logical 1,1/0,1/1,0/0,0) to Machs Axis selection (X,Y,Z,A)  and Galilis digital input IN3+IN4(logical.....) to machs handwheel resolution (config/geneal config 0.1/0.01/0.001/0.0001/)
Cooling will be activated by IN5+IN6+IN7+IN8 logical (1/1/0/1)
Ref by logical (0/1/0/1)
I hope some can help me with the implementation.

In advance, thanks for your efforts

Regards
Claus

Pages: 1