Hello Guest it is September 17, 2019, 05:33:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - eagle550

Pages: 1
1
General Mach Discussion / Re: Tool problem!
« on: October 09, 2006, 06:08:26 PM »
Thank you it is working out now.

Arthur

2
General Mach Discussion / Re: Tool problem!
« on: October 09, 2006, 01:36:47 PM »
Hi Graham,

Oke so I need cutter compensation but is that not automaticly done in the G-code. If not how do I put it in the G-code or can I already put in the G-code when I use LazyCam?

Arthur

3
General Mach Discussion / Tool problem!
« on: October 09, 2006, 10:44:36 AM »
Hi,

I just finisched the conversion of my X1 mill and started with mach 3 to mill some stuff. But how do I program the g-code that it knows how big my endmill is. Because I tryed a lot but still he does not do it right, all my figure millled out are to small because of the endmill. I added tools to my tool path and select the right tool in the layers of the dxf file but still not the way I like it. I hope you all understand my problem.

Greets,

Arthur

4
General Mach Discussion / Re: Using Mach3 on notebook
« on: October 08, 2006, 12:14:11 PM »
Hi,

Well thank's for the answer (sorry for my late response). I ordered the card and I am looking forward to use it soon. I will let know if it works.

Eagle

5
General Mach Discussion / Using Mach3 on notebook
« on: October 01, 2006, 10:25:39 AM »
Hi all,

I am using mach3 now, but I am wondering if it is possible if you can use mach 3 on a notebook and then a notebook without a parallel port. I readed in the mach3 manual that it was not possible to use mach3 with a USB - Parallel cable. But I found some other hardware what is not using the USB port but the PCMCIA card slot of the note book. I am wondering if some have any experience with something like this. Here is the link of the product I am talking about.
http://www.transdigital.net/info.htm

Greets,

Eagle550

Pages: 1