Hello Guest it is July 19, 2019, 11:49:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - glbaird

Pages: 1
1
General Mach Discussion / Re: Understanding Driver Test
« on: June 20, 2008, 05:53:15 PM »
Thanks Hood

I have dc steppers with gecko 203V drivers and all seems to work fine I was unsure of the reason for the mhz changing need

I have tested at 100000 mhz and during the complete test only 2 small jogs in the test line

thanks again Greg

2
General Mach Discussion / Understanding Driver Test
« on: June 20, 2008, 12:10:35 PM »
I have Mach3 running fine no problems but cannot find any info on setting the configuration up for
the 25000 mhz or can I use 45000mhz I have done the driver test and it looks like all is fine up to the 65000mhz
test but again don't know the advantage to change from the 25000mhz setting

Anyone have more info on this why change to higher mhz setting if it works at 25000 Why is this option even in Mach3
if we don't know how to use it I have read the complete manual and find nothing that covers it

thanks Greg

Pages: 1