Messages

1

LazyCam (Beta) / Multipass wizard offseting

« on: September 21, 2008, 08:42:58 PM »

mach 3 multipass wizard will cut the first pass perfectly but when it comes to the second cut it offsets in the y about 1/2 inch or more. any reason for this?

2

LazyCam (Beta) / Re: mach 3 multipass wizard question?

« on: September 18, 2008, 08:39:12 PM »

One would think so, I might be setting up lazycam wrong; though I have tried multiple times, and my job wont multipas cut. If I run it through the wizard however it works great.

3

LazyCam (Beta) / Re: mach 3 multipass wizard question?

« on: September 18, 2008, 08:06:52 PM »

Yes I am.

4

LazyCam (Beta) / mach 3 multipass wizard question?

« on: September 17, 2008, 03:10:11 PM »

If I open a g-code in mach 3 and run it through the multipass wizard, setting the cut depth, and how deep to cut every pass; do I need to set a cutting depth for the same project in lazy cam? would the 2 cancel each other out or would I end up with a mell of a hess?

5

LazyCam (Beta) / Re: Lcam chain depth

« on: August 11, 2008, 05:21:52 PM »

To kool,  thanks much

6

LazyCam (Beta) / Lcam chain depth

« on: August 11, 2008, 03:56:36 PM »

 In a given DFX file with multiple chains, can I assign different depths to different chains?

7

General Mach Discussion / Not cutting all the way through problem?

« on: July 07, 2008, 05:20:06 AM »

Im wondering if anyone has an answer to my problem.

I take a jpg or whatever, vectorize it and save it as a wmf, I then open it in lazy cam; create a gcode, and then run it in Mach 3.

However lets say I cut a simple circle, from the start point of cutting to the end point of cutting there is not a complete circle. There is still about 1/8th of an inch of material not cut to complete the 360 degres of the circle?

What am I doing wrong or missiing in lazy cam.

Thanks much for any help.