Hello Guest it is March 28, 2024, 10:30:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cletusrace

Pages: 1
1
Show"N"Tell ( Your Machines) / Re: Monty's Problematic Contraption
« on: May 21, 2008, 02:11:29 AM »
Hi I have bridgebort seriesII with the boss5 control on it and was wondering if I was going to retrofit it with a new control what would you recommend for a breakout board to use to control the stepper motors?  Any help would be greatly appreciated.

Thanks,

2
Hi my name is Aaron aka cletusrace.  I found this sight looking for some info. on master5 software and looking for info. on the stepper3 driver board.  I have been using cnc equipment for about 13 yrs.  Looking for some info. on trying to retrofit a brigdeport cnc with a boss5 control to use a stepper3 board and was going to us master5 software, but see they don't make that software anymore and are useing mach3 now.

Pages: 1