1
General Mach Discussion / Re: THC and Z axis floating head once agine
« on: December 01, 2008, 03:13:57 PM »
Sound Logic solve my problem.
"Make sure the the pin you use for Z home is not used for anything else.
In other words if Z home is on port 1 pin 13 make sure port 1 pin 13 in not used anywhere else in the config."
I have to check reversed on Z axis in home/limit setup.
THX again Jim
"Make sure the the pin you use for Z home is not used for anything else.
In other words if Z home is on port 1 pin 13 make sure port 1 pin 13 in not used anywhere else in the config."
I have to check reversed on Z axis in home/limit setup.
THX again Jim