Hello Guest it is August 11, 2020, 03:54:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Mr_bossman

Pages: 1
Hi I'm from Whitby,ON,Canada,
My son and I  built a 36" x 42" home made router cnc with extruded aluminum  it took about nine months .We are using Mack3 , Vcarve 2d and TurboCad ver14 software.Having lots of fun.Started to run out of room in my garage so we mounted the unit on the wall ( from horizontal to Vertical ) looks and works great.

Hi people,I have been a member for about 6 months but not spending much time on the site due to other things going on.Hope to get more involved in the near .

Pages: 1