Hello Guest it is November 30, 2021, 07:41:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bill C

Pages: 1
1
General Mach Discussion / Re: Post Processor
« on: May 09, 2008, 03:31:06 PM »
I'm not sure what code or file type En Route generates. It's probably a standard G Code. I don't have the post to send my files to Mach 3. This is an old version that doesn't have all the post processors listed.

Thanks and the photo of Sam  make me laugh. She must be family.

2
General Mach Discussion / Re: Post Processor
« on: May 07, 2008, 05:09:18 PM »
I guess this should be the post from EnRoute 3 to Mach 3

3
General Mach Discussion / Post Processor
« on: May 07, 2008, 11:18:04 AM »
Where can I locate a post processor for Enroute 3?

Pages: 1